1. 安装网卡
机器太新，以至于现有的Linux版本无法认出，比如机器找不到网卡，这时候怎么办呢？


别急，首先你需要知道网卡是什么型号的，以本实验室新购入的电脑为例，它的网卡是集成的，型号是Realtek RTL8168/8111 PCI-E Gigabit Ethernet NIC。然后我们到Realtek的官方网站去下载相应的Linux驱动程序r8168-8.005.00.tar.bz2，按照说明安装。


Unpack the tarball :

# tar vjxf r8168-8.aaa.bb.tar.bz2

Change to the directory:

# cd r8168-8.aaa.bb

If you are running the target kernel, then you should be able to do :

# make clean modules (as root or with sudo)

# make install

# /sbin/depmod -a

# /sbin/insmod ./src/r8168.ko (or r8168.o in linux kernel 2.4.x)


You can check whether the driver is loaded by using following commands.


# /sbin/lsmod | grep r8168(看看有没有加载网卡驱动)

# /sbin/ifconfig –a(看看有没有相关网卡被启动的信息)


If there is a device name, ethX, shown on the monitor, the linux


driver is loaded. Then, you can use the following command to activate

the ethX.


# ifconfig ethX up

,where X=0,1,2,...


这里也可以通过系统→管理→网络来设置IP地址等，最后激活。


1. Set manually


a. Set the IP address of your machine.


# ifconfig ethX "the IP address of your machine"


b. Set the IP address of DNS.


Insert the following configuration in /etc/resolv.conf.

nameserver "the IP address of DNS"


c. Set the IP address of gateway.


# route add default gw "the IP address of gateway"


2. Set by doing configurations in /etc/sysconfig/network-scripts


/ifcfg-ethX for Redhat and Fedora, or /etc/sysconfig/network

/ifcfg-ethX for SuSE. There are two examples to set network

configurations.


a. Fix IP address:


DEVICE=eth0

BOOTPROTO=static

ONBOOT=yes

TYPE=ethernet

NETMASK=255.255.255.0

IPADDR=192.168.1.1

GATEWAY=192.168.1.254

BROADCAST=192.168.1.255


2. 修改：＃vi /etc/hosts，在该文本中，增加两行：


127.0.0.1 localhost.localdomain localhost

192.168.4.101 node3（根据机器本身情况设置）


修改：vi /etc/hosts.equiv，增加一行：(如果没有该文本，可建立一个)


node3


3. 启动ssh服务


大部分的Linux版本应该都会自带该程序


＃ssh-keygen

＃cd .ssh

＃cp id_rsa.pub authorized_keys

＃ssh node3（如果成功，会显示上次登陆的时间， node3是主机名）


附加信息：

ifup eth0看看能否启动eth0

lsmod看看有没有加载网卡驱动

dmesg看看有没有网卡启动时的错误信息